© Elsys AG
Page 2
Plug-In Channel Module
Front View
Rear View
Control Elements
Front Side
Main switch (Base Unit) :To switch on or off the device.
LED-Displays
: Each LED belongs to a channel, from which it indicates the pulse
signal on the channel output.
Rotary switch
GAIN
: Rotary switches named
GAIN
. This switches adjusts the gain for
one channel. Possible gain factors are 1, 10, 100 and automatic.
Toggle switch
Pol.
: Switches named
Pol
. This switches can invert (-) or not invert (+)
the output signal of the preamplifier.
Position left (+)
: Trigger-Pulse on negative slope (Diff. = off), and neg. peak
values (Diff. = on).
Position right (-) : Trigger-Pulse on pos. slope (Diff. = off), and pos. peak values
(Diff. = on).
Toggle switch
Diff.
: Switches named
Diff
. Each one switches on or off the
differentiator for one channel. If the differentiator is on, the signal
is attenuated at the input by a
factor of 50
.
Toggle switch
dU/dt
: Switches named
dU/dt.
Each switch is for changing the time
constant from the differentiator for one channel. For low
frequency signals (<1kHz) it’s preferred to choose the operating
position “flat slope” (left), for fast signals (>1kHz) the operating
position “steep slope” (right) should be selected.
