If you want to know the cellular networks available at the installation site, perform the following steps:
Before mounting the reflector on the AMPLIMAX and before connecting the SIM Card, take the AMPLIMAX cabinet to a location
close to the final installation. Remove the AMPLIMAX cover and connect the network cable from the POE, as shown below:
POWER
SOURCE 24V
NETWORK CABLE
RJ45 / Ethernet
ANT EXT
ANT
INT/EXT
RJ45/POE
4G
SIM CARD
4G
POE
EASY INSTALL
BLIND SEARCH OF CARRIERS
Keep the product without
the SIM Card at this time
Hold it up so that
it can follow the
information on
the display.
As soon as the product is turned on, the display must
show the "Boot" ( ) message followed by "Load"
( ) and “---” Soon after, it displays the power of
supply that arrives at the product, which must be
greater than or equal to 9V ( ) Make sure that the
product is missing the SIM Card and wait for the
display show the message "nSIM" ( )
Then, press the
“Easy Install"
key, so that the equipment
starts the "Blind Search". Lift the product and hold it at
its bottom, so as not to impair the functioning of your
antenna, as shown in the figure on the side:
The
"Blind Search"
may take a few minutes, depending on the location and configuration of the product. At the end of this
period, the display will show the list of available cellular networks, organized by technology: (E.g.: 4G and 3G) and the level of
each one. (See
list of networks
in OPERATION). If no cellular networks are found, try searching elsewhere. The search will only
be performed on the technologies (4G and 3G) selected on the AMPLIMAX configuration web page. The factory setting will
search for 4G and 3G networks.
Once the "Blind search" has started, the process cannot be interrupted, and it must wait until the results obtained are
displayed. If you wish to interrupt the display of the Blind Search results, simply press the
"Easy Install"
key again.
Generally, the better the carrier level, the better the data rate. Keep in mind, however, that when the reflector is fitted and the
correct pointing is made, the level of the selected carrier tends to increase significantly.
Note:
In some regions, an carrier that has a cellular network may rent its infrastructure to another carrier. In this way, the same
signal will be shared by the two carriers. In this case, the search will show only the carrier name that owns the cellular network.
CELL
NETWORK
EASY
INSTALL
CELL
NETWORK
EASY
INSTALL
4G
