14
2.2 - LIST OF THE FUNCTIONS
Learning of the STROKE OF THE PEDAL
It allows to keep the total stroke of the pedal installed in console or to reduce
the stroke.
Learning of the STROKE OF THE ROD
It allows to regulate the stroke of the rod according to the needs of opening of
the swell box.
Regulation of the MINIMUM SPEED of movement of the engine
It allows to regulate set the minimum speed of movement of the engine
according to the minimum power necessary to move the doors of the swell box.
Regulation of the MAXIMUM SPEED of movement of the engine
It allows to reduce the maximum speed of movement of the engine
preset as maximum value.
Regulation of the ACCELERATION/BRAKING RAMP of the engine
It allows to regulate the slope of the acceleration/braking ramps, namely to
establish the sweetness of the movement of the swell box, in departure and
arrival.
STANDARD OPENING CURVE
Preset opening curve, not linear:
the first steps are very short, the last ones
are longer.
Memorization of a PERSONALIZED OPENING CURVE
It allows to memorize, step by step, a personalized opening curve according to
one's own needs.
Selection of the POSITION OF THE SWELL BOX AT THE STOP OF THE ORGAN
At the stop of the organ it is possible to open the doors of the swell box
automatically, close or leave them unchanged (namely in the position
where they are in the moment of the stop of the organ).
Selection of the kind of CONTACTS: TRUE OR FALSE
It allows to adapt the system to the two types of existing contact pedal: with
opened contacts that close themselves, with closed contacts that open
themselves.
INTERNAL POTENTIOMETER FOR THE SIMULATION OF THE PEDAL
It is available, on the board inside the command panel, a potentiometer
that, with
the appropriate settings, can simulate the pedal of the console. In this way, some
test and regulations can be made directly to the control unit, without using the
console.
WORKING TEST
Series of tests and useful functions that offer a support during the testing phase:
