27
L O G o f f
N O M O R E R U N S
Data can be downloaded at any time (even during logging) without loss of
recordings.
4.9 The CHANNEL SETUP function
This is used to select the channels and set the range for each channel.
Each model has a specified combination of channels, please consult the
data sheet in Section 13 for details of your particular model. Once you
enter this function, you will be informed of the number of channels that
have currently been selected: -
C H A N N E L S E T U P
9 u s e d
Pressing select will enable you to scroll through all of the channels. Some
of the channels may not be currently selected, and these will be indicated
as follows: -
C H 5
n o t u s e d
Holding down the set button will allow you to set up the channel: -
C H 5
H O L D T O C H A N G E
Then, each time
set
is pressed, the display will reveal the available
measuring ranges for that channel. Once you have set the appropriate
range for a particular channel, you can at any time press
select
to view
another channel
’s setup status. However, if logging is in progress then it
will not be possible to change the channel setup and the following will be
displayed: -
C H 3 ° C
L O G G I N G
If logging has stopped, but there are readings stored in memory, it is still
not possible to change channel setup and the following is displayed: -
