4
ESR series routers
1.
ANNOTATION
This guide coverages instruction of connection to power supply, factory device configuration and
basic ESR series router configuration recommendations (hereafter referred to as the device).
The guide is destined for technical staff that performs installation, configuration and putting the
device into operation.
2.
DESIGN
The design of the devices is described in this section. The front, back, side panels' images are
represented, and the connectors, light indicators and controls are described below.
The device enclosed in metal case available for 19” form-factor rack-mount, case height 1U.
2.1.
ESR-1000, ESR-1200 design
ESR-1200 front panel
The front panel of ESR-1200 is represented in figure 2.1.
Figure 2.1 - Front panel of ESR-1200
The list of connectors, light indicators and controls that are located on the front panel of ESR-1200
are described in Table 2.1.
Table 2.1– Description of connectors, light indicators and controls located on the front panel of ESR-1200
№
Front panel element
Description
1
SD
SD-card connector.
2
USB1
USB-device port.
3
USB2
USB-device port.
4
[1 .. 12]
12 x Gigabit Ethernet 10/100/1000Base-T (RJ-45) ports.
5
Combo Ports
4 x Gigabit Ethernet 10/100/1000Base-X (SFP) ports.
6
XG1 - XG8
10G SFP+/ 1G SFP transceiver installation slots.
7
Status
Indicator of device's current state.
Alarm
indicator of alarm existence and emergency level.
HA
НА operation mode indicator.
Flash
Activity indicator of exchange with data storages (SD-card or USB Flash).
Power
Device power indicator.