120
LTP-8X(config)# profile ports Ports1
LTP-8X(config-ports)("Ports1")# port 0 bridge group 10
LTP-8X(config-ports)("Ports1")# port 1 bridge group 11
LTP-8X(config-ports)("Ports1")# igmp multicast dynamic-entry 0 vid 98
LTP-8X(config-ports)("Ports1")# igmp multicast dynamic-entry 0 group 224.0.0.1
239.255.255.255
LTP-8X(config-ports)("Ports1")# port 1 multicast
LTP-8X(config-ports)("Ports1")# port 1 igmp downstream vid 98
LTP-8X(config-ports)("Ports1")# port 1 igmp downstream tag-control remove-tag
Step 8.
Check the changes made.
LTP-8X(config-ports)("Ports1")# do show profile ports Ports1
...
Igmp settings:
...
Multicast dynamic entry [0]:
Vlan id: 98
First group ip: 224.0.0.1
Last group ip: 239.255.255.255
...
Port [0]:
Speed: auto
Duplex: auto
Bridge group: 10
Spanning tree for bridge group: false
Multicast enable: true
Multicast port settings:
Upstream igmp vid: 1
Upstream igmp prio: 0
Upstream igmp tag control: pass
Downstream multicast vid: 1
Downstream multicast prio: 0
Downstream multicast tag control: pass
Max groups: 0
Max multicast bandwidth: 0
Shaper downstream:
Enable: false
Commited rate: 1000000
Shaper upstream:
Enable: false
Commited rate: 1000000
Port [1]:
Speed: auto
Duplex: auto
Bridge group: 11
Spanning tree for bridge group: false
Multicast enable: false
Multicast port settings:
Upstream igmp vid: 1
Upstream igmp prio: 0
Upstream igmp tag control: pass
Downstream multicast vid: 98
Downstream multicast prio: 0
Downstream multicast tag control: remove-tag
Max groups: 0
Max multicast bandwidth: 0
Shaper downstream:
Enable: false
Commited rate: 1000000
Shaper upstream:
Enable: false
Commited rate: 1000000
Step 9.
Set up a management profile. To do this, create a cross-connect profile and assign it with the
management
type and the
bridged
model:
LTP-8X(config)# profile cross-connect management
LTP-8X(config-cross-connect)("management")# bridge
LTP-8X(config-cross-connect)("management")# outer vid 9
Summary of Contents for LTP-4X
