34
Chapter 9.
Getting Started with Terminal CLI
Introduction
CLI is the main means of communication between user and the terminal. This chapter considers general
operations in CLI: commands grouping, automatic code completion, and history.
9.1
CLI Views Hierarchy
Views are used in the terminal CLI to group commands and optimize their length.
Fig. 9.1 shows a graphic chart of main views and the commands to switch between them.
Fig. 9.1 – CLI Views Hierarchy
The
Top view
includes general commands, which refer to the device in general. For instance: view
terminal parameters, firmware update, reboot, etc. The
Switch view
is a group of switch-related commands:
VLAN, GE interfaces, LACP, etc. The
Configure view
is a list of terminal configuration commands. For instance:
user management, services configuration, GPON interface and ONT configuration, profile configuration, etc.
Summary of Contents for LTP-4X
