41
LTP-8X(config)# backup on save
Step 3.
The terminal can be adjusted to use a timer for configuration upload if necessary. In this case,
additionally set the timer period in seconds.
LTP-8X(config)# backup on timer
LTP-8X(config)# backup timer period 3600
Step 4.
Check the entered data by using the
do show backup
command.
LTP-8X(config)# do show backup
Tftp:
Backup on conf save:
enabled
Backup on timer:
enabled
Backup on timer period:
3600
Backup uri:
’tftp://192.168.1.1/config’
Step 5.
Apply the changes.
LTP-8X(config)# do commit
10.5
Configuration Restore
The terminal configuration is restored from a TFTP server which is available in the management network.
The
copy
command is used to restore the data. Define source URI as parameter and fs://config as restored
configuration.
LTP-8X# copy tftp://10.0.105.1/config fs://config Download file from TFTP-server..
Reading of the configuration file..
Configuration have been successfully restored (all not saved changes was lost)
10.6
Configuration Reset
To reset a terminal configuration to factory settings, use the command.
LTP-8X# default
Do you really want to set up default configuration? (y/n) y
Configuration have been reseted to default.
Terminal will be reloaded.
Resetting a configuration of a remote terminal also resets network settings. The
terminal will not be available for operation until the network settings are
reconfigured.
Summary of Contents for LTP-4X
