43
Step 6.
Set the management VLAN of the terminal by using the
management vid
command if necessary.
Use
management cos
to set the
P-bit
parameter for the management VLAN.
LTP-8X(config)# management vid 9
LTP-8X(config)# management cos 5
Proper operation of the inband management function requires VLAN adjustment in
the switch view as described in Chapter 15.
Step 7.
Set MAC addresses aging by using the
gpon network mac-age-time
command.
Pass time in seconds as a parameter.
LTP-8X(config)# gpon network mac-age-time 7200
Step 8.
The network settings will change as soon as the configuration is applied. No terminal reboot is
needed.
LTP-8X(config)# do commit
Summary of Contents for LTP-4X
