74
Step 2.
Enable the interface by using the
no shutdown
command. On the contrary, the
shutdown
command disables the interface.
LTP-8X(switch)(config-if)# no shutdown
Step 3.
Enable or disable flow control (IEEE 802.3x PAUSE) by using the
flow-control
command.
LTP-8X(switch)(config-if)# flow-control on
Step 4.
Enable or disable incoming packets filtering by using the
ingress-filtering
command. Only the
packets of the VLANs, which have this interface, will pass the enabled filter. Other packets will be filtered
out. If the filter is disabled, a packet will be processed regardless of its VID field.
LTP-8X(switch)(config-if)# ingress-filtering
Step 5.
Specify a rule for VLAN tags processing for incoming packets by using the
frame-types
command. As a parameter, specify the packets to be allowed: either
tagged
(tagged only) or
all
(both
tagged and untagged).
LTP-8X(switch)(config-if)# frame-types tagged
Step 6.
Specify the port
pvid
, i. e. the VLAN, which will accommodate untagged packets. Specify the
pup
value, which is the priority of untagged packets.
LTP-8X(switch)(config-if)# pvid 100
LTP-8X(switch)(config-if)# pup 0
Step 7.
If necessary, enable or disable packets transfer from this interface to another one (or a range of
interfaces) by using the
bridging to
command. Pass interface type and number (or a range) as parameters.
The interface types and numbers are given in Table 16.1.
All front-port interfaces are isolated by default, however data can be sent to any pon-port interface. The
same is applicable to pon-port interfaces, which are isolated from each other, but can send data to any
front-port interfaces.
LTP-8X(switch)(config-if)# bridging to front-port 1
Step 8.
If needed, use the
spanning-tree
command group to adjust the STP protocol.
LTP-8X(switch)(config-if)# spanning-tree enable
LTP-8X(switch)(config-if)# spanning-tree priority 32
LTP-8X(switch)(config-if)# spanning-tree pathcost 0
LTP-8X(switch)(config-if)# spanning-tree admin-p2p auto
LTP-8X(switch)(config-if)# spanning-tree admin-edge
Summary of Contents for LTP-4X
