User manual for NV-510-WB 57
APPENDIX B
INSTRUCTIONS FOR PROGRAMMING THE TV ON/OFF BUTTON OF BLUETOOTH
REMOTE CONTROL
To use TV ON/OFF button to turn on/off your TV, you need to program it. To do this:
1.
Press and hold the TV ON/OFF button –
– for about 3 seconds. When the remote indicator
lights up red, you can release the button.
2.
Press the TV button again. The indicator will start flickering — the remote control's button is ready to
receive a new function.
3.
Point the set-top box's remote control and the TV remote control at each other (keep the remotes at
a distance of 3-5 cm).
4.
Press the ON/OFF button on the TV's remote control.
If the learning has been successfully finished, the red indicator will blink 3 times, then it will light
permanently.
If the learning has not been performed, the indicator will flicker quickly and after 10 seconds will
light permanently. In this case, repeat steps 2-4.
5.
After successful learning, press any button except TV ON/OFF to exit the learning mode.
