ELTEX SCC-P, Operating Instructions Manual

14

BA-en-2087-2207_Static Combi Cleaner SCC-P

It is intended that the apron (3) be shortened to dimension (C) by the cus-
tomer and a contour be cut if necessary. The 1 mm thick conductive poly-
carbonate film should be worked on with a suitable cutting tool. From an 
apron length (C) of less than 60 mm, the lower wire clamp is no longer 
necessary..

3.4 Connecting the high voltage cable to the ion blower nozzle

The high voltage cable is fixed permanently to the ion blower nozzle.

3.5 Connecting the high voltage cable to the power supplies of

series ES5x, ES6x and PI

Warning!

Connect or disconnect the high voltage cables only with the power supply 
switched off!
Connect the ion blower nozzles to the power supply using the prefabrica-
ted high voltage cable. Push the high voltage cables into the sockets up to 
the stop. Then secure the cable in the socket with the clip provided (see 
Fig. 5). 

Warning!

In applications involving moving ion blower nozzles, the high voltage cable 
must be attached such that there is no cable movement near the connec-
tion zone of the ion blower nozzles and the power supply unit. Use sui-
table clamps to attach the high voltage cables.

3.6 Connecting to ground 

In units equipped with existing ground cables, the cables must be perma-
nently connected to ground potential. The ground cable should have a 
minimum cross section of 1.5 mm

2

.

Fig. 5:
Connecting the 
high voltage cable

Z001

78

y