____________________________________________________________________________________
____________________________________________________________________________________
TAU-4M.IP Subscriber gateway
71
Call reply timeout, s
- if there will be no answer to group call, the call resets after this time interval;
Group Call Pickup Enable
- when checked group call pickup is allowed. Call pickup is possible only
if call group subscribers are belong one pickup group (see Section 2.6.3.1 The 'Pickup Groups'
submenu).
List of the Ports
- when checked, a line (port) will be included into this call group.
To apply a new configuration and store settings into the non-volatile memory, click the
'Apply' button.
To
discard changes click the
'Cancel'
button.
2.6.3.7
'Pickup Groups' submenu
The
'Pickup groups'
submenu is intended for call pickup groups configuration.
Pickup group–subscriber group, authorized to receive (or intercept) any calls directed at another
subscriber of the group. I.e. each subscriber that belongs to the group will be able to pickup the call received on
any other port of this group by dialling a pickup code. Pickup code configuration is carried out in the
'Dialplan'
point in the
'Profiles'
submenu.
To add/delete the line in group, select/deselect the checkbox next to the respective group.
To apply a new configuration and store settings into the non-volatile memory, click the
'Apply' button.
To
discard changes click the
'Cancel'
button.
Service usage:
The call comes in to the phone unit of a subscriber that belongs to the pickup group. If subscriber cannot
answer the call, another subscriber that belongs to that group and that uses the same SIP profile may answer
the incoming call. To do this, they should dial a pickup code, and the connection with the caller will be
established after that.
Pay attention that call pickup is possible only if called and pickup subscribers using the same SIP profile.
Pickup group may be used in combination with a call group; in this case, all ports that belong to a call
group should belong to the pickup group as well. In this case, each port that belong to a pickup group will be
able to pickup an incoming call to a group number.
When subscriber dials the pickup code when there are no incoming calls to a group number or phone
port, ‘Busy’ tone will be transmitted to subscriber.