____________________________________________________________________________________
____________________________________________________________________________________
TAU-4M.IP Subscriber gateway
105
2.8
Configuration example
Connect the PC to one of the device's LAN ports, connect the wire from the provider's network to the
WAN port;
In the address bar of the browser, enter the IP address of the gateway (by default 192.168.1.1);
When the device connection is established, a window will appear asking for your login and
password. Fill in the fields and click the 'Log In' button (Default login: admin, password: password).
If this window does not appear, make sure that the automatic connection to obtain an IP address is set in
the network connection settings on your PC.
In the 'Internet' tile you can configure external connection. If
TAU-4M.IP
will be used as a router -
select the value of the 'Work mode' field - the router in the 'Internet' tile. In the 'Protocol' field,
select the protocol used by your internet service provider and enter the required data according
to the provider’s instructions. If you use the static settings, select
Static
value in the ‘Protocol’
field and fill the ‘WAN IP’, ‘Netmask’, ‘Default gateway’, ‘1st DNS Server’, and ‘2nd DNS Server’
fields with the corresponding values obtained from the provider. To save and apply changes, click
.
To specify additional parameters, go to advanced settings mode by clicking the ‘more’ link (see Section
If your Internet provider’s network uses binding to the MAC address, click the 'more' in the
'Internet' tile and open the 'MAC management' submenu. In the 'Set MAC address for WAN'
section, check the 'Redefine MAC' flag and enter the MAC address of the device that was