____________________________________________________________________________________
____________________________________________________________________________________
VoIP subscriber gateways
67
Hunt groups provides functions of call processing center. The device is supported by 3 operation mode of
hunt groups: group, serial and cyclic.
In ‘
group
’
mode, the call will be sent to all the free group ports simultaneously. If one participant of call
group answers, the call to other ports is stopped.
In ‘
serial
’
mode call will be sent to the first free port in the list and, after specified timeout, the next free
port from the list will be added to the main port. When one of the group participants answers, the call to the
other free ports will be finished.
In ‘
cycle
’
mode the free participant of the group is searched by timeout. Thus, cyclical calls
each after each
will be sent to all the free group ports.
Adding of a new group
–
Enable group
–
when checked, call group is enabled otherwise call group is disabled;
–
Group name
–
identification group name;
–
SIP profile
– SIP profile used by call group;
–
Phone
–
phone number assigned to the group;
–
User Name
–
username for authentication on SIP server;
–
Password
–
password for authentication on SIP server;
–
Type of group
–
call group type:
Group
– call group signal will be sent to all the ports of group simultaneously;
Serial
– port number, that call will be forwarded to, will be increased by one when
zero value is defined for call timeout of the next port;
Cyclic
– cadence through the interval, that is equal to timeout of the next port
calling, will be transmitted to each port of group cyclically;
–
Next port calling timeout, sec
–
option is used by ‘serial’ and ’cyclic’
group types and option assigns time interval to switch a call to following
port(s);
–
Call queue size
– setting allows you to limit maximum number of unanswered calls to call group
queue. If the group has free port and unanswered calls, incoming call is not put on the queue.
–
Call reply timeout, sec
–
if
group call is not answered, it will be dropped after timeout expiration
(calling subscriber receives ‘busy’ signal);
–
SIP Port of group
– alternative SIP port of group (the default value is 5060);
–
Group call pickup enable
– when checked, group call interception is permitted. Call interception is
available only if call group subscribers belong to the same group SIP profile;
–
Ports
– to add port into serial group, click the preferred port in the
‘Available’
list and drag it to the
‘Added’
list. Take into account that the order of ports is important because of searching free port
will be performed from the top of the list downwards (the top port of the list will be called as first).
To add new group, click ‘Save’. To cancel adding a new group, click ‘Cancel’ button.
To edit record in ‘Action’ column of ‘Hunt group’ table, click
button. To delete record, click
button.
To store settings into non-volatile memory, click ‘Apply’ button.
Changes in this submenu will be applied immediately after pressing
‘
Apply
’
button. Reboot is
not required.
