____________________________________________________________________________________
____________________________________________________________________________________
86
VoIP subscriber gateways
no route
Call to inaccessible direction
local clear
Call release of TAU subscriber
remote clear
Call release of remote subscriber
local fail
Local or remote error arisen under establishing a connection. The
error source may be: mismatch codecs, reboot, source luck (band
pass) and etc.
remote fail
remote redirection
Redirecting (before the call – CFB, CFNA, CFU or during the call-CT) is
performed by a remote subscriber
local redirection
Redirecting (before the call – CFB, CFNA, CFU or during the call-CT) is
performed by TAU subscriber
Replaced
Subscriber status, when the ‘Call Transfer’ service is performed
Ranking of records
Table records can be gradated by any parameter if click on the arrow of column header by left mouse
button. The direction of ranking is specified next to the header that is highlighted in red color and can be
changed by pressing the left button of mouse.
-
put in order of increasing;
–
put in order of decreasing.
Record filtering
Call history records can be filtered by one
or several parameters.
Filter list:
–
FXS ports
–
FXS port number of the
device;
–
Local number
–
TAU subscriber
number;
–
Remote
number
–
remote
subscriber number;
–
Opposite side IP address
–
IP
address of a remote host;
–
Call received time from/to
–
call received/performed time period in the 'hh:mm:ss dd.mm.yyyy'
format (for example, for 22 February 2012 at 6:31 p.m.): "
18:31 02/22/2012
", "
22 feb 2012
18:31:00
", "
6:31:00 pm 22 February 2012
" and etc.;
–
Call start time from/to
–
call start time period in the 'hh:mm:ss dd.mm.yyyy' format (for example,
for 22 February 2012 at 6:31 p.m.): "
18:31 02/22/2012
", "
22 feb 2012 18:31:00
", "
6:31:00 pm 22
February 2012
" and etc.
If the assigned data is not found, it will be highlighted in red color.
–
Call status
–
transient state
or a reason of call termination;
–
Call type
–
call type (all types), outgoing and incoming.
To filter log by assigned parameters, click ‘Apply filter’ button. To translate all filter values back to initial
state, click ‘Cancel’ button.
