WB-15-W. User manual
20
•
•
•
•
•
•
•
•
•
R
- indicates that the route was most likely created by a dynamic routing protocol running on the local
system using the reinstate parameter;
D
- indicates that the route was added as a result of receiving an ICMP Redirect Message. When the
system learns the route from the ICMP Redirect message, the route will be added into the routing
table in order to exclude redirection of the following packets intended for the same destination.
M
– means that the route was modified – likely by a dynamic routing protocol running on a local
system with the 'mod' parameter applied;
A
- points to a buffered route to which an entry in the ARP table corresponds.
C
– means that the route source is the core routing buffer;
L
- indicates that the destination of the route is one of the addresses of this computer. Such «local
routes» exist in the routing buffer only.
B
– means that the route destination is a broadcasting address. Such 'broadcast routes' exist in the
routing buffer only.
I
- indicates that the route is connected to a ring (loopback) interface for a purpose other than to
access the ring network. Such 'internal routes' exist in the routing buffer only.
!
– means that datagrams sent to this address will be rejected by the system.
4.4.3 The «Mobile network» submenu
In the «Mobile network» submenu you can view the current status and parameters of the connection to the mobile
network.
