WB-2P-LR5. User manual
20
•
•
•
•
•
•
•
5.1
The «Monitoring» menu
To move to the system monitoring mode, select «Monitoring» on the left panel.
5.1.1 The «Internet» submenu
In the Internet submenu, you may view main network parameters of the device.
Internet Connection
Network connection
– the parameter shows the type of connection to the external network;
Connection Status
– the parameter shows state of connection to the external network;
SSID
– a name of wireless network, to which the device is connected;
Access Protocol
– a protocol which is used for access to the external network;
IP Address
– device IP address in the external network;
Link Capacity
– parameter that reflects the effectiveness of the use of a modulation by the device on the
transmission. It is calculated based on the number of packets transmitted on each modulation, and the
reduction factors. The maximum value is 100% (means that all packets are transmitted at maximum
modulation for the maximum nss type supported by the device). The minimum value is 2% (in the case
when the packets are transmitted to the modulation nss1mcs0 for the device with MIMO 3x3 support). The
parameter value is calculated for the last 10 s;
Link Quality
– parameter that displays the status of the link, calculated based on the number of sent
retransmit packets. The maximum value is 100% (all transmitted packets were sent on the first attempt), the
Some pages are not updated automatically. To obtain current state of the device, press
.
