WB-2P-LR5. User manual
30
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
SSID
– wireless network ID, which is used for base station connection. The maximum name lenght – 32
symbols, the keyboard register is important. The name may consist of digits, latin letters and symbols «-»,
«_», «.», «!», «;», «#» and space, although it is forbidden to start with the symbols «!», «;», «#» and space.
Scan Environment
– press the button to start scanning at the defined range. The list of found access points
will be displayed. The list of access points consists of seven coloumns: access point SSID, security mode,
MAC address, channel, channel bandwidth, frequency, signal level. If you select any access point from the
list, SSID field will be filled automatically, and the corresponding mode will be selected.
802.11 Mode
– select wireless interface operation mode:
802.11a
– the standard supposes maximum rate of up to 54 Mbps;
802.11n
– the standard supposes maximum rate of up to 300 Mbps;
802.11ac
– the standard supposes maximum rate of up to 866.7 Mbps.
Channel Bandwidth
– channel bandwidth, on which a Wi-Fi client operates. The parameter may take values
from 5, 10, 20, 40 and 80 MHz. Note, that channel bandwidth of 80 MHz will operate only according to
802.11ac standard. If the base station has 5 or 10 MHz bandwidth, you should select the same bandwidth
on the user station.
Security mode
– select security mode for wireless network:
Off
– encryption of the wireless network is off, low security.
WEP
– WEP authentication. WEP-key should consist of hexadecimal digits and be of 10 or 26 symbols
lenght or it might be a string (a-z, A-Z, 0-9, ~!@#$%^&*()_-+= symbols) with lenght of 5 or 13 symbols.
The mode is hidden in the web interface.
WPA, WPA2
– WPA and WPA2 authentication. The key lenght is from 8 to 63 symbols. Only the
following characters can be used: a-z, A-Z, 0-9, ~!@#$%^&*()_-+=;:
|/?.,<>"`' or space. It is recommended to use WPA and WPA2 encryption modes as the safetest.
WPA-Enterprise, WPA2-Enterprise
– WPA and WPA2 encryption with client authentication via 802.1x.
Enter username and password as authentication data.
Tx Power (dBm)
– transmitting Wi-Fi signal power adjustment, dBm.
Short Guard Interval
– support for shortened guard interval. 400 ns interval is used (instead of 800 ns).
Fixed center frequency
–
when the flag is checked, all traffic (data and
management packets) will be
transmitted on the specified center channel frequency with a given bandwidth (40 or 80 MHz). The function
is proprietary, the transmission is not carried out according to IEEE 802.11 standards, where it is supposed
to use different center frequencies for data and management traffic with 40/80 MHz bandwidth. When
using the WB-2P-LR5 with WOP-2ac-LR5 devices with enabled fixed center frequency, activation at the
subscriber station is not required, because happens automatically at the moment of connection to the base
station.
Limit Channels
– the list of frequencies on which the air is scanned to connect to the base station. For
example, if a channel 100L (5490-5530) with a 40 MHz band is set on the BS, then in the list of allowed
channels should be selected
all the channels in this frequency range
: 98 - 106 channel inclusive. With this