WB-2P-LR5. User manual
33
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Use General VLAN
–
when checked, one VLAN specified in the General VLAN ID field will be removed and
the traffic of this VLAN will go to the client without a tag. When traffic flows in the opposite direction,
untagged traffic will be tagged with General VLAN ID:
General VLAN ID
– VLAN identifier;
General 802.1P
– 802.1P attribute (also called CoS – Class of Service), which is attached to egress packets
transmitted from this interface. The value is from 0 (the least priority) to 7 (the highest priority);
Transparent mode - when checked, the device will pass untagged traffic in the VLAN trunk mode.
VLAN trunk in router mode
VLAN Trunk
– if checked, the trunk port is activated. There is an opportunity to use Management VLAN and
Internet VLAN:
Use Management VLAN
– when checked, management VLAN used for access to the device is enabled:
Management VLAN ID
– VLAN identifier, which is used to access the device;
Management 802.1P
– 802.1P attribute (also called CoS – Class of Service), which is attached to
egress IP packets transmitted from this interface. The value is from 0 (the least priority) to 7 (the
highest priority).
Management Protocol
– defines management interface operation mode:
DHCP
– operation mode, when IP address, subnet mask, DNS server address, defualt gateway
and other parameters required for operation are obtained from DHCP server automatically.
Static
– operation mode where IP address and all the necessary parameters for interface are
assigned statically. If «Static» is selected, the following parameters will be available to set:
Management IP
– set IP address of interface of the device in service provider network;
Management netmask
– set subnet mask of device's interface in service provider
network;
Management Default Gateway
– address, to which a packet will be transmitted in case the
route has not been found in the route table;