WB-2P-LR5. User manual
44
•
•
•
•
•
•
NAT rules
To add a new NAT rule, click
Add
button and fill in the following fields in the Add a new rule window:
Name
– name of the rule (it is obligitory to fill the field);
LAN IP Address
– IP address of host in local network. Packets translated to this host will follow the rule;
Destination ports of LAN
– receiver TCP/UDP ports, via which packets are translated to local network (you
may assign either single port or range of ports using dash);
Protocol
– selection of the packet protocol falling under this rule: TCP, UDP, TCP/UDP;
WAN IP address
– source IP address in external network which will be under the rule;
Destination Ports of WAN
– destination TCP/UDP ports in external network, packets from which will follow
the rule (you may assign either single port or range of ports using dash).
Port forwarding rule will work as follows: a packet received via
«Protocol»
on a port defined in
«Destination Ports
of WAN»
field and having source address defined in
«WAN IP address»
field (if the field is empty, source IP does
not consider) undergoes address and Destination port substitute with the parameters defined in
«LAN IP Address»
and
«Destination Ports of LAN»
fields respectively.
Press
«Apply»
button to add a new rule. To discard changes click
Cancel
button.
To delete an entry from the list, select corresponding checkbox and press «Remove».
