WB-2P-LR5. User manual
46
•
•
•
•
•
•
•
or 192.168.16.0/255.255.255.0 to set addresses range (the subnet mask entry /24 coincides
with /255.255.255.0 entry);
Output
– outgoing traffic (traffic which is generated by the device locally from a network interface). If
the parameter is selected, the following field will be displayed:
Destination IP address
– set destination IP address. You may set subnet mask after «/»
character. The subnet mask should be set in the following formats: xxx.xxx.xxx.xxx or xx,
e.g. 192.168.16.0/24 or 192.168.16.0/255.255.255.0 to set addresses range (the subnet mask
entry /24 coincides with /255.255.255.0 entry);
Protocol
– a protocol of the packets, which will follow the rule: TCP, UDP, TCP/UDP, ICMP, any;
Action
– an action for packets to undergo (accept/drop).
When TCP, UDP, TCP/UDP protocols are selected, the following settings will be available to configure:
Source ports
– the list of source ports, packets from which will follow the rule (it is acceptable to specify
single port or range of ports using the dash sign). To specify all the source ports, enter «0–65535»;
Destination ports
– the list of destination ports, packets from which will follow the rule (it is acceptable to
specify single port or range of ports using the dash sign). To specify all the source ports, enter «0–65535».
When ICMP is selected, the following settings will be available for editting:
Type of ICMP Message
–
you may create a rule for a certain ICMP messages type or for all types.
Press «Apply» button to add a new rule. Press «Cancel» to discard the changes. To delete a created rule, check the
box next to the rule and press «Remove».
