WB-2P-LR5. User manual
49
•
•
•
•
•
•
•
•
•
•
•
•
•
5.2.10 The «SNMP» submenu
WB-2P-LR5
software allows monitoring of the device status and its sensors via SNMP. In SNMP submenu, you can
configure settings of SNMP agent. The device supports SNMPv1, SNMPv2c.
Enable SNMP
– when checked, SNMP will be enabled for utilization;
Read-only Community
– a password to read the parameters (by default:
public
);
Read-write Community
– a password to configure (write) parameters (by default:
private
);
TrapSink
– an IP address or domain name of SNMPv1-trap messages receiver in HOST [COMMUNITY
[PORT]] format;
Trap2Sink
– an IP address or domain name of SNMPv2-trap messages receiver in HOST [COMMUNITY
[PORT]] format;
InformSink
– an IP address or domain name of Inform messages receiver in HOST [COMMUNITY [PORT]]
format;
System Name
– device name;
Contact
– the manufacturer contact;
Location
– information on the device location;
Trap Community
– a password which is contained in traps (by default: trap).
The list of objects which are supported for reading and configuration via SNMP is given below:
eltexLtd.1.164.1
– WB-2P-LR5 parameters monitoring;
eltexLtd.1.166.1
– WB-2P-LR5 rev. B parameters monitoring;
eltexLtd.1.167.1
– WB-2P-LR5 rev. C parameters monitoring.
where eltexLtd – 1.3.6.1.4.1.35265 is Eltex Enterprise identifier.
To apply a new configuration and save setting to non-volatile memory, press «Apply». Press «Cancel» to discard
the changes.