WB-2P-LR5. User manual
5
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
2 Device description
2.1 Purpose
User station WB-2P-LR5 (herein after «the device») is designed for access provision to secure wireless network.
The device provides access to up-to-date interactive services: Internet, IPTV, VoIP.
WB-2P-LR5 connects to a base station via Wi-Fi technology and operates at 5 and 6 GHz (the frequency range –
5830-6150 MHz – is supported on WB-2P-LR5 rev.B and WB-2P-LR5 rev.C). The device is supposed to operate
with WOP-2ac-LR5. WB-2P-LR5 might be also used for wireless bridge organization.
WB-2P-LR5 supports up-to-date requirements to service quality and allows transmitting more important traffic in
higher priorities queues. Prioritization is based on QoS technologies: CoS (special tags in VLAN packet field) and
ToS (tags in IP packet field).
The device is capable to operate in wide temperature range and in high-humidity conditions (parks, factories,
stadiums, etc.).
Power to the device is supplied via PoE technology 24V.
2.2 Device specification
Interfaces:
LAN: 1 port Ethernet RJ-45 10/100/1000BASE-T;
WLAN: IEEE 802.11a/n/ac;
Service Wi-Fi 2.4 GHz 802.11b/g/n
(short-range interface for adjustment and device setup during the
installation period)
1
The power is supplied via PoE injector 24V connected to 220V network.
1
For WB-2P-LR5 rev.C.
Network functions:
operating in bridge and router modes;
operating in «Wi-Fi Station» and «Wireless bridge» modes;
support for VLAN Trunk;
support for Management VLAN;
support for General VLAN;
support for Transparent Mode;
static routing;
support for Transparent wireless bridge function;
support for PPPoE client;
time synchronization via NTP;
support for static address and DHCP (DHCP client on WAN side, DHCP server on LAN side);
support for DNS;
support for D-DNS;
support for NAT;
support for UPnP;
firewall;
support for cloning of MAC address on WAN interface;
support for quality of service mechanisms (QoS through DSCP and 802.1P).
Do not use an injector with voltage different from 24V so as not to break down the device!