WEP-3ax, WEP-3ax-Z. User manual
43
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Hostname
– network name of the device, specified by string from 1 to 63 characters; latin uppercase
and lowercase letters, numbers, hyphen '-' (hyphen can not be the last character in the name);
AP Location
– domain of the EMS management system tree host where the access point is located;
Management VLAN
:
Disabled
– Management VLAN is not used;
Terminating
– the mode in which the management VLAN is terminated at the access point; in this
case, clients connected via the radio interface do not have access to this VLAN;
Forwarding
– the mode in which the management VLAN is also transmitted to the radio interface
(with the appropriate VAP configuration).
VLAN ID
– the VLAN ID used to access the device, takes values 1-4094;
Protocol
– select protocol for connection of the device via Ethernet interface to service provider network:
DHCP
– operation mode, when IP address, subnet mask, DNS server address, defualt gateway and
other parameters required for operation are obtained from DHCP server automatically;
Static
– operation mode where IP address and all the necessary parameters for WAN interface are
assigned statically. If "Static" is selected, the following parameters will be available to set:
Static IP
– device WAN interface IP address in the provider network;
Netmask
– external subnet mask;
Gateway
– address, to which the packet is sent, if the route in routing table is not found for
it;
Primary DNS Server, Secondary DNS Server
–
IP address of DNS servers. If DNS servers' addresses
are not allocated automatically via DHCP, set them manually.
To apply a new configuration and save setting to non-volatile memory, click "Apply". Click "Cancel" to discard
the changes.
5.7.2 The "Access" submenu
In the
"Access"
submenu, you can configure access to the device via the WEB interface, Telnet, SSH, NETCONF
and SNMP.
To enable access to the device via the WEB interface via HTTP protocol, set the flag next to "WEB". In the
window that appears, it is possible to change the HTTP port (by default, 80). The range of acceptable
values of ports, in addition to the default, from 1025 to 65535 inclusive;
To enable access to the device via the WEB interface via HTTPS protocol, set the flag next to "WEB-
HTTPS". In the window that appears, it is possible to change the HTTPS port (by default, 443). The range
of acceptable values of ports, in addition to the default, from 1025 to 65535 inclusive;
