Water Comfort System · Operating Manual Electronic Temperature Control Unit ELTC-W
BU-091 - 008TCWE
Page 3 of 10
Firmware V0.5.0
Revision 3
Product description
• Electronic temperature control unit for heating cables on water pipes
Standard functions
• LCD-Display with plain text, operation with 4 buttons
Operating / Operating elements
LCD-Display for
Parameters and data
cursor buttons
up/down
leave list
open list /
start programming /
confirm data
Alarm
On = Output activated.
Alarmbeeper can be accepted by pressing any button
Frost protection
On = Output activated
Heating tape
On = Relay connected, P=100%
Blinking = soft start active, P < 100%
Operation
On = self test
Blinking = normal operation
Blinking quickly = fault operation
Programming
All readable and adjustable data (parameters) have been summarized in
lists. During normal operation or if no button is pushed for at least 1 minute
the following information appears:
Parameter lists
ELTC-W 10:49[WE]
>Standard-mode
Standard Display
Controller type
Time (24h mode)
↓
↑
ELTC-W 10:49[WE]
Working mode or
error message
Button
Action
>Standard-mode
Weekday
RET
↓
ESC
↑
ESC
.......... > 3 seconds, back to general display
RET
........... Open overview of parameter lists
........ select a parameter list
ELTC-W 10:49[WE]
1)Base settings
→
RET
Grundeinstellungen
Base Settings
RET
........... select a parameter list
........ select parameter to be programmed
RET
........... start programming, parameter name blinks.
←
ESC
Optionally an identification is required.
........ choose settings, keeping cursor button
pushed, accelerates the display of data.
ELTC-W 10:49[WE]
2)Setu p
→
RET
Sollwerte Einstellung
Settings
RET
........... end programming
ESC
........... brings you back to list overview.
←
ESC
ELTC-W 10:50[WE]
3)Timers
→
RET
Zeiteinstellungen
Timers
←
ESC
ELTC-W 10:50[WE]
4)Antifreeze
→
RET
Frostschutz
Frost Protection
←
ESC
ELTC-W 10:51[WE]
5)Info
→
RET
Information
Info
←
ESC
Caution
Please observe safety instructions!
ESC
..........> 3 seconds, back to general display
RET
..........Open overview of parameter lists
.........select a parameter list
RET
..........select a parameter list
.........select parameter to be programmed
RET
..........start programming, parameter name blinks.
Optionally an identification is required.
.........choose settings, keeping cursor button
pushed, accelerates the display of data.
RET
..........end programming
ESC
..........brings you back to list overview.
Identification
This display appears:
Access Code
0
[1]
this parameter then protects against an inadvertent use by a code.
The controller requests the entering of the code
42
.
After having entered the additional code the output switches
off. The reactivation will be effected by pressing the button
ESC for >3 seconds; after 60 seconds automatically without
keystroke: The code will be deleted again and the main
display will be activated at the same time.
