9
www.eltherm.com
9
www.eltherm.com
7
Fasten the mount-
ing stand onto the
pipe with a strap.
8
Mount the heating cable
connection (
not included
with delivery of Ex-TC
).
PREPARATION FOR THE ELECTRICAL CONNECTION
2
Insert a flat-tip
screwdriver between the
locking arm and the
rear bar and
push the locking arm for-
ward a few millimetres by
turning the screwdriver
3
Turn the headless
screw back with the Allen
wrench (size 2) until it is
protruding slightly
out of the locking arm.
OPENING THE HOUSING
1
Tighten the headless
screw with an Allen
wrench (size 2) until the
locking arm is flush with
the side bars
4
Raise the
cover (using
the-screwdriver)
5
Open the
cover (using
the-screwdriver)
REMOVING THE CONTROLLER
6
Loosen retaining
screws
7
Slide controller
out of the locking
mechanism
