Step by step
27
9.6 Adjustment of the loader position when placing the crucible on the pedestal
Press the adjustment button shortly so many times, until the step 14 of the sequence is reached
and the crucible in the fingers is situated over the pedestal. Move the complete loader to the
position when the crucible is situated centrally over the pedestal. Look from the front and from
the side to be able to estimate the position of the crucible.
Adjust the height of the complete loader the following way. Loose the safety nut on the feet of
the loader, rotate the feet of the loader using a hex key or a screw driver until the appropriate
height of the crucible over the pedestal is adjusted. The height is adjusted correctly if the arm
and crucible do not move at the moment, when fingers open and the crucible is released. Fix
the safety nut. Adjust all the feet the same way to ensure that the complete loader platform is
positioned horizontally and there is no tilt of the platform, resp. the arm.
Summary of Contents for CHS-580A
