AutoSense
Gap Sensor
Adjustment
Load labels into the printer.
Do not use the
auto-dispense/peeler mode for this procedure.
Press and hold the PAUSE and CANCEL con-
trol buttons with the power on. Release the
CANCEL button first and then release the
PAUSE button.
The printer will start feeding labels automati-
cally. The printer will automatically adjust the
gap sensor and measure the label length.
After the sensor has been adjusted, the printer
will enter DUMP mode and print the standard
information label.
Press the FEED button once to switch the
printer back to normal operation. If the Error
indicator light (continues) to glow AMBER/OR-
ANGE, refer to Appendix A for troubleshoot-
ing information.
980158-001 Rev.A
27
Operation
Summary of Contents for Eclipse LP2344
