Label Sensors
Your printer is equipped with a sensor capable
of detecting the gap between labels while they
are being printed. This feature depends on the
ability of the sensor to
“see through”
the label
liner between labels. The printer is also
equipped with a Black Line sensor. This type
of sensor is used with special labels or tags that
have a black line printed on the back of the
label liner between each label.
Due to manufacturing differences in label
stock, the
see through
sensor may have diffi-
culty distinguishing the difference between la-
bels and the liner. When this occurs, the printer
Power Indicator will switch from GREEN to
ORANGE or RED. If this condition occurs, the
AutoSense Gap Sensor Adjustment feature (on
the following page) should be activated to ad-
just the sensitivity of the sensor.
Operation
16
980088-001 Rev. A
Step
➋
Charge Battery
Before using the printer for the first time, the
battery must be charged. After inserting the
battery, attach the overnight charger to the
charger port on the left side of the printer.
Check the input voltage rating on the charger
and plug into an appropriate A.C. outlet.
Before using a battery for the first time, it must
be charged for 4-6 hours with the overnight
charger.
The printer and charger should never be
operated in a location where either one can get
wet. Personal injury could result.
Figure 2
Charge the Battery
Getting Started
980088-001 Rev. A
5
