Step
➋
Place one end of the roll against the roll holder
and push to open. Position the roll between the
holders and release.
For dispensing labels still attached to the liner,
pull the label leader over the print head latch.
The P2242 is designed to automatically peel
labels from non-perforated liners. For dispens-
ing labels that are automatically peeled from
the liner, thread the end of the leader through
the print head latch.
Figure 2-3
Insert the Roll
Figure 2-4
Automatically
Dispensed Label
Threading
Operation
14
980088-001 Rev. A
Step
➍
Install Software
Start your computer. After DOS has loaded,
insert the Create-A-Label Tools diskette into
your floppy disk drive. From the DOS prompt,
enter B:INSTALL (or A:INSTALL if you placed
the diskette in drive A). Press the Enter key.
Follow the installation instructions on the
screen to install the software.
Refer to Section 2 - Operation, for information
on loading labels and using your printer.
Getting Started
980088-001 Rev. A
7
