elvita CFB3102V, User Manual

15

GB

TEMPERATURE CONTROL

•  Connect the freezer to a working power outlet. The “Power” indicator comes on. The  

  “Run” indicator shines when the freezer is running. The “Alarm” indicator shines when the  

  temperature in the freezer is too high. 

•  Use the thermostat knob to set freezer temperature. The numbers “1”, “2”, “3”, “4”, “5”  

  and “6” do not represent specific temperatures. However, the lower the number, the  

  higher the temperature in the freezer (and vice versa). 

•  When the thermostat knob is in the “OFF” position, the freezer is off.

LOCATION

•  Before using the freezer, remove all packaging materials (this includes impact protection,  

  foam rubber and tape from inside the freezer). Remove the protective film from the door  

  and the sides of the freezer.

•  Place the freezer indoors in a well-ventilated place. The surface must be flat and sturdy. 

•  Protect the freezer from heat sources and direct sunlight. Do not place the freezer in wet  

  or damp environments. Rust can otherwise arise and impair insulation.

•  There must be at least 70 cm clear space above the freezer and at least 20 cm clear  

  space around the sides and the rear of the freezer. This is to facilitate opening, closing  

  and heat dissipation.

•  Use a warm damp cloth to wipe the interior and exterior of the freezer (add a little  

  detergent to warm water and give a final wipe over with water only).

STARTING

Let the freezer run for two to three hours before placing fresh or frozen foodstuffs in it.  

In the summer, increase this time to 4 hours. This is because the ambient temperature is 

higher then.