65
GB
Troubleshooting
Warning!
Before trouble-shooting, disconnect the power supply. Only a
qualified electrician or other skilled personnel should perform troubleshooting that
is not in the manual.
Important!
Repairs to the appliance may only be performed by competent service engineers. Improper
repairs can give rise to significant hazards for the user. If your appliance needs to be repai-
red, please contact your specialist dealer or your local Customer Service Centre.
Problem
Possible cause
Solution
Appliance does not work Appliance is not switched on.
Switch on the appliance.
Mains plug is not plugged in or is loose.
Plug the appliance into the electric socket.
Fuse has blown or is defective.
Check fuse, replace if necessary.
Outlet is defective.
Defective parts need to be repaired by an
electrician.
Appliance cools too
much.
Temperature is set too cold.
Turn the temperature regulator to a warmer
setting temporarily.
The food is too warm.
Temperature is not properly adjusted.
Please refer to the initial start up section.
Door was open for an extended period.
Open the door for only as long as necessary.
A large quantity of warm food was placed
in the appliance within the last 24 hours.
Turn the Control Panel to a colder setting
temporarily.
The appliance is near a heat source.
Please refer to the installation location section.
Interior lighting does not
work.
Light bulb is defective.
Please look in the changing the light bulb
section.
Heavy build-up of frost,
possibly also on the door
seal.
Door seal is not air-tight (possibly after
reversing the door).
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool setting).
At the same time, shape the warmed door
seal by hand so that it is correctly positioned.
Unusual noises.
Appliance is not level.
Readjust the feet.
The appliance is touching the wall or other
objects.
Move the appliance slightly.
A component, e.g. a pipe, on the rear of
the appliance is touching another part of
the appliance or the wall.
If necessary, carefully bend the component
out of the way.
The compressor does not
start immediately after
changing the tempera-
ture setting.
This is normal, no error has occurred.
The compressor starts after a period of time.
Water on the floor or
storage shelves.
Water drain hole is blocked
Refer to the cleaning and care section.