32
Installation
© 2020, Elon Group AB. All rights reserved.
1.
Remove the clamp protection cover.
2.
Open the terminal board cover.
3.
Install the bridge.
4.
Secure the cable wires to the terminal board using the screws.
WARNING! Make sure the protective earth wire is properly secured.
5.
Secure the cable with the clip.
6.
Close the terminal board cover.
7.
Install the clamp protection cover.
Do the following after the connection is completed
1.
Make sure the mains power has been correctly installed.
2.
Check that the heaters, control and governing elements are working correctly.
Set maximum hob power
Maximum hob power is 7200 W by default. If the available power or the fuse size is limited, set a lower maximum power.
1.
Connect the cooker to the mains.
2.
Touch
and hold for 1 second to turn off the child lock.
3.
Touch
for the rear left and the front right cooking zones simultaneously.
The current maximum power is displayed.
4.
Touch
or
to set the desired maximum power.
Available power settings are 7200 W, 6000 W, 3500 W, and 2800 W.
5.
Touch
for the upper left and the lower right cooking zone at the same time again to store the new setting.
is displayed on the selected cooking zone when the maximum hob power is reached. Depending on the set maximum
power, it may not be possible to use a high power level for several cooking zones at the same time.