30
31
© 2021, Elon Group AB. All rights reserved.
8. Undo the screws that hold the middle hinge and remove the
hinge. Then remove the lower door.
9. Place the lower door on a smooth surface with its panel
upwards. Undo screw 3 and remove part 2 and part 1. lnstall
the replacement door stopper 1 (supplied in the plastic bag) and
part 2 (stop block) on the left side of the door using screw 3.
Keep part 1 with the appliance for future use.
10. Transfer the screw hole covers on the middle cover plate
from left to right (as shown in figure below).
11. Tip the refrigerator backwards, remove part 3 and then
remove screws 4.
12. Remove part 5 from the lower hinge pin, then remove the
lower hinge pin, transfer it to the hole on the opposite side, fix it
in this position, then install part 5 on the lower hinge pin.
13. Remove part 3 from part 2, then remove screws 4.
14. Replace the items that you removed in step 11, transfer part 1
to the left side and part 2 to the right side and then fix them with
screws 4. Finally install part 3.
15. Slot the lower door on to the bottom hinge pin and hold it
in position. Rotate the middle hinge through 180°, transfer the
washer on the pivot to the lower side, adjust the middle hinge
to the appropriate position and then install it ensuring that the
lower door is secured in place.
1. Lower hinge part (right)
2. Front foot fixed board
3. Adjustable bottom feet
4. Self-tapping screws
5. Adjustable bottom feet
Lower hinge part (left)
1. Door stopper
2. Stop block
3. Self-tapping screw
Note: washer may stick to lower door
Washer
