37
© 2021, Elon Group AB. All rights reserved.
CLEANING AND CARE
For reasons of hygiene the appliance (including exterior and
interior accessories) should be cleaned regularly at least every
two months.
Caution!
The appliance must be disconnected from the mains
supply before cleaning. Danger of electrical shock! Before
cleaning, turn off the appliance and unplug it from the power
socket.
Exterior cleaning
To keep your appliance looking good, you should clean it
regularly.
- Wipe the digital panel and display panel with a clean, soft
cloth.
- Spray water on to the cleaning cloth instead of spraying
directly on to the surface of the appliance. This helps ensure an
even distribution of moisture across the surface.
- Clean the doors, handles and cabinet surfaces with a mild
detergent and then wipe dry with a soft cloth.
Caution!
- Do not use sharp objects as they are likely to scratch the
surface.
- Do not use paint thinner, car detergent, chlorine-based
detergents, essential oils, abrasive cleansers or organic solvents
such as benzene for cleaning. These may damage the surface
of the appliance and may cause a fire.
lnterior cleaning
• You should clean the interior of the appliance regularly. It
will be easier to clean when there is little food inside. Wipe the
inside of the fridge freezer with a weak solution of bicarbonate
of soda, then rinse with warm water using a damp sponge or
cloth. Wipe completely dry before replacing the shelves and
baskets. Thoroughly dry all surfaces and removable parts.
• Although this appliance automatically defrosts itself, a layer of
frost may build up on the freezer compartment’s interior walls if
the freezer door is opened frequently or left open for too long.
lf the frost is too thick, choose a time when there is little food in
the appliance, and proceed as follows:
1. Remove existing food and accessory baskets, unplug the
appliance from the power socket and leave the doors open.
Ventilate the room thoroughly to accelerate the thawing
process.
2. When defrosting is completed, clean your freezer as
described above. Caution! Do not use sharp objects to remove
frost from the freezer compartment. Wait until the interior is
completely dry before plugging in the appliance and switching
it back on.
Cleaning the door seals
Take care to keep door seals clean. Sticky food and drinks can
cause seals to stick to the cabinet and tear when you open the
door. Wash seals with a mild detergent and warm water. Rinse
and dry thoroughly after cleaning.
Caution!
Only after the door seals are completely dry should
the appliance be turned back on.
Replacing the LED light:
Warning: The LED light must not be replaced by the user! lf
the LED light is damaged, contact the customer helpline for
assistance. To replace the LED light, follow the steps below:
1. Unplug your appliance.
2. Remove light cover by pushing up and out.
3. Hold the LED cover with one hand and pull it with the other
hand while pressing the connector latch.
4. Replace the LED light and snap it correctly in place
