5
EN
DESCRIPTION
Wireless programmable digital keypad for outdoor use. Used for controlling automation systems for gates and garage doors, wi-
thout the need to carry out any connection. EDT2 is powered by one type AAA 2 X 1.5 V battery pack with harness and transmits
commands via radio frequency (433.92 MHz), similarly to a remote control.
PACK CONTENTS
EDT2 keypad
Battery pack
4 screws for internal fixing
2 screws with anchors for wall-mount installation
2 screws for fixing the keypad
Instruction sheet
OPERATION
Connect the EDT2 battery to the keypad through the appropriate connector.
The keypad will behave like a two-channel remote control: by entering a code from 4 to 8 digits and pressing button “A” (or “B”),
a radio signal will be transmitted as channel 1 (or 2). Within 3.5 seconds from last entry, the same signal can be retransmitted by
pressing “A” or “B” without having to enter the code again.
PROGRAMMING ON RECEIVER/CONTROL BOARD
EDT2 requires an ELVOX control board with built-in receiver or an ECRU external receiver. Refer to the instruction manual of
the receiver for programming.
WARNING:
It is not possible to assign the same code to two or more keypads onto the same receiver.
BATTERY LIFE SPAN
Activations/day*
Expected battery life (years)**
2
3
5
2,5
10
2
* Activations lasting approx. 10 sec. The transmission time after pressing channel A or B is 2 seconds. he backlight turns off 3.5
seconds after the last button was pressed; once channel A or B are pressed, the backlight goes off immediately to preserve
battery charge.
** Average temperature 25°C
WARNING:
Dispose of the battery according to relevant regulations in force
TECHNICAL DATA
EDT2
Power supply
Battery pack batterie AAA 2 x 1,5 V
Open sight range
30 m towards receiver with built-in antenna
Frequency
433,92 MHz
Operating temperature
-20 / +50 °C
Encoding type
Rolling Code Elvox
Number of usable codes on
keypad
12.000.000.000
Protection degree
IP54
Overall dimensions
80 x 90 x 35 mm
