15
Operation
Hours
Completed (Date or Hours)
1.10
Complete bolt and screw check
25
1.11
General lubrication
4)
25
2.
ENGINE
1)
2.1
Replacement of the engine oil
…
2.2
Air filter cleaning and check
…
2.3
Air filter replacement
…
2.4
Fuel filter check
…
2.5
Fuel filter replacement
…
2.6
Spark plug points cleaning and check
…
2.7
Replace spark plug
…
1)
See the engine manual for the full list and frequency.
2)
At the first signs of any malfunction, contact your Dealer.
3)
The operation must be carried out by your Dealer or a specialized Service Centre.
4)
General lubrication of all joints should also be carried out whenever the machine is to be left un
-
used for a long period.
6.2.1
Engine (Fig. 6.1)
IMPORTANT
Follow all the instructions in the
engine manual.
To empty the oil from the engine, hold the ex
-
tension tube (1) firmly in place and unscrew the
drain plug (2).
When refitting the plug (2) make sure the seal
(3) is positioned correctly and tighten it as far as
possible, holding the extension tube (1) firmly in
place.
6.2.2
Rear axle
This is a sealed single unit that does not require
maintenance. It is permanently lubricated and
its lubricant does not need changing or topping
up.
6.2.3
Battery (Fig. 6.2)
To ensure long life to the battery it is essential to
keep it carefully maintained.
The machine battery must always be charged:
– before using the machine for the first time
after purchase;
– before leaving the machine disused for a long
period;
– before starting up the machine after a pro
-
longed period of inactivity.
Carefully read and observe the battery recharg
-
ing instructions in the booklet provided with the
battery. Failure in following the procedure or in
charging the battery could permanently damage
the battery elements.
A flat battery
must
be recharged as soon as
possible.
IMPORTANT
Recharging must be done us-
ing a battery charger at constant voltage. Other
recharging systems can irreversibly damage the
battery.
The machine comes with a connector (1) for re
-
charging; this is connected to the corresponding
connector for the special maintenance battery-
charger supplied (if included) or available on
request (see 8.5).
IMPORTANT
This connector must only be
used for connection to the maintenance battery-
charger indicated by the Manufacturer. For its
use:
– follow the indications given in the relative in-
structions manual;
– follow the instructions in the battery manual.
Summary of Contents for KJK 102H Series
