Nighthawk Pro
www.emaxmodel.com
１０
（
8
）
Move throttle stick up
（
9
）
Use transmitter stick to control pitch, roll and yaw, observe the motor power bar under "Motor Testing". Make sure
the motor power bar is change according to transmitter stick.
（
10
）
Test motor direction: Use a piece of paper to touch the motor to check the motor direction (Motor direction should
be the same as figure shown below) Please be careful and only move the motor little by little while checking motor
direction.
Step 5 Installation
Caution:
①
Because the power cannot transmit in time, to avoid video transmitter burnt out, ,
please install the antenna before power on when testing and using video transmitter.
②
This light is high-heating to ensure the brightness. Please donot touch when using it
or may be scalded. Caution high temperature!
After all testing completed, disconnect micro USB and disconnect battery.
（
1
）
Place velcro to frame (about center of gravity of the frame, depend on battery size, battery can be placed inside the
copter frame or above the copter frame) See Fig 1.
（2）Place receiver behind the camera on the middle board, stay away from the video transmission antenna.
（3）
Place receiver antenna into receiver antenna base, and install receiver antenna base to the frame. (There are 2 ways
to install the receiver antenna, customer can choose the best way depend on receiver size) See Fig2, Fig3 and Fig4.
（4）Please install video transmitter antenna to video transmitter. See Fig 2.
（5）Please install propeller to motors (Beware of the CW and CCW propellers) M1 and M4 are CCW propellers,
M2 and M3 are CW propellers.
（6）Please remove camera cover and turn on monitor and/or power goggle.
（
7
）Connect battery to power copter, and switch the video transmitter power to ON and check video
feed from monitor and/or goggle.
（
8
）
Please adjust camera lens focus to best image quality.
