Operation
The LEDs
display the power levels, intensity level
and run-on function of the ventilator.
Display
The power levels, intensity level and run-on
function are shown in the display on the moving
section.
Fan ON/OFF
Reduced fan level
Increased fan level
Run-on, if this button is pressed, the
ventilator continues to operate at level
I
and switches off automatically after
15 minutes.
Move hood upwards
Move hood downwards
The fan has 3 power levels for normal use and an
intensity level for occasional use with an
increased power setting. After 30 minutes, the
control automatically switches the intensity level
back to level 3.
It is recommended to allow the fan to continue
operating for a few minutes after cooking. This
helps to remove any remaining steam and odours
from the air.
The run-on function provides the option of having
the fan switch off automatically after 15 minutes.
The extractor fan features a filter cleaning display
which reminds you to clean the filters after 30
hours of service.
After this operating time, the power level display
flashes.
After cleaning the filters, the
button is
pressed until the power level display flashes.
The filter cleaning display then starts again from
zero.
Cleaning and care
Visible soiling must be removed from the fat
filters.
Excessively greasy filters pose a fire risk.
To clean the filters remove these from the
extractor fan using the filter key. The filters are
attached at the top with a magnetic tape and
hooked in place on the bottom.
If necessary, the metal filter can be
removed from the filter housing for
cleaning.
These parts can be cleaned in a dishwasher or
with hot water and a cleaning agent.
Do not use a
high-pressure cleaner
!
2