Assembly of foot extensions
(only for extraction model)
As of a kitchen work surface height in excess of
850 mm, the foot extensions supplied must be
assembled.
To do this, place the device on its side and
screw out the adjustable feet (they have a
cross recess on the bottom for a cordless
screwdriver) Attach the extension panel to the
housing via the thread holes of the adjustable
feet using the four hexagon socket screws
attached. Screw the adjustable feet into
extension panel.
Assembly
Assemble the control panel in a suitable place
(cable length: 2 m). The standard control panel
is attached using two countersunk bolts. To
enable flush-mount assembly, another control
panel is an R2 corner radius is included.
The front plate can be replaced by unscrewing
the rosettes on the LEDs.
Place the device below the work surface cut-out.
Make sure that the front of the device (sticker
front = filter side) faces towards the cooking
area. Lift the device into the cut-out by turning
out the adjustable feet. To set the final height,
place the cover on the device. Set the height so
that the cover is flush with the work surface.
Align the device vertically.
Kitchen work surfaces which are thinner than 34
mm can be prevented from sagging by using
thread screws M4x25 which are screwed into
the upper frame.
Connect the end of the control panel cable to
the connector on the control board of the main
control (control for ventilator).
The control panel does not have to be
assembled with remote-controlled models. In
such cases, the antenna which is secured to the
back of the housing for transportation, must be
positioned to ensure a good radio link to the
portable transmitter.
Electrical connection for extraction mode
Check
that the supply voltage corresponds to the
details on the rating plate.
For devices between 600 and 800 mm, the
controls are mounted on the front (filter side).
The connectors for the mains and ventilator are
located on the ventilator control. You require
two sockets for the power supply.
4
