Magnet
Lifting cylinder attachment
Note
If work on the building site is not yet complete,
there is a risk that the device could be
operated by third parties. Dirt and sand grains
could fall between the guide and housing and
cause scratches. Disconnect the device from
the power supply during this time.
Initialisation run
Should the hood no longer move or the device
moves up and down at an angle, an
initialisation run must be performed.
The system is initialised by pressing the
button.
If must be depressed until the drives have
reached the bottom position.
Release for 5 seconds.
Hold down the button for a further 10
seconds.
The system is lowered slightly and lifted up
again during initialisation. The initialisation run
is then complete.
Please do not let go of the down button during
the initialisation run.
If you let go of this button before the run is
complete, this process is interrupted and must
be started again. If the initialisation run is
interrupted, the system cannot be moved
upwards. Should it not be possible to perform
an initialisation run, either the connecting
cables of both controls have been
disconnected, the lifting movement control is
faulty or a lifting cylinder is no longer working.
Maintenance
Firstly disconnect the device from the power
supply before performing any repairs or
maintenance work.
We hope you enjoy using your new extractor
fan.
6
