Page | 129
[ +5
]
（
enter +5
）
Command (m for help):
[ t ]
（
type t
）
Selected partition 1
Hex code (type L to list codes):
[ c ]
(type c to set partition
type)
Changed system type of partition 1 to c (W95 FAT32 (LBA))
11.
Type
a
and
1
to set the TF card to bootable mode;
Command (m for help):
[ a ]
Partition number (1-4):
[ 1 ]
12.
Type the letters as shown in the following table to create a
partition for the root filesystem;
Command (m for help):
[ n ]
(type n to create a partition)
Command action
e extended
p primary partition (1-4)
[ p ]
(type p to select primary partition)
Partition number (1-4):
[ 2 ]
(set partition number to 2)
First cylinder (7-61, default 7):
[ ]
(press Enter key on your
keyboard)
Using default value 52
Last cylinder or +size or +sizeM or +sizeK (7-61, default 61):
[ ]
(press Enter key)
Using default value 245
13.
Type p to check the created partitions as shown below;
Command (m for help):
[ p ]
Disk /dev/sdc: 2021 MB, 2021654528 bytes
255 heads, 63 sectors/track, 245 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sdc1 * 1 6 409626 c W95 FAT32
(LBA)
/dev/sdc2 7 61 1558305 83 Linux
Summary of Contents for SBC8140
