Page | 77
2.
Execute the following instruction to view the contents of the SD
card;
root@SBC8140:/media#
ls mmcblk0p1/
The information in the HyperTerminal window is shown below;
flash-uboot.bin u-boot.bin x-load.bin.ift_for_NAND
mlo uImage
ramdisk.gz ubi.img
3.8.5
Testing a USB Device
Testing of a USB device is accomplished by creating a network
communication between the miniUSB interface on the kit and a USB
interface on the PC;
1.
After the system boots up, connect the SBC8140 to your PC
with a Mini B-to-USB A cable, then install the Linux USB
Ethernet driver; please refer to Appendix 2:Driver Installation
Of Linux USB Ethernet/RNDIS Gadget
Error! Reference
source not found.
.
2.
Execute the following instructions to set the IP addresses of the
SBC8140 (the IP used below is only for reference; you can
select a different IP as required);
root@SBC8140:~#
ifconfig usb0 192.168.1.115
root@SBC8140:~#
ifconfig
The information in the HyperTerminal window is shown below;
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:26 errors:0 dropped:0 overruns:0 frame:0
TX packets:26 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2316 (2.2 KiB) TX bytes:2316 (2.2 KiB)
usb0 Link encap:Ethernet HWaddr 5E:C5:F6:D4:2B:91
inet
addr:192.168.1.115
Bcast:192.168.1.255
Mask:255.255.255.0
Summary of Contents for SBC8140
