- 12 -
For requirement b) Mounting a self adhesive print on board:
Pull of 3-4 cm of the liner of the self adhesive print and stick the print onto the board manually.
Move the board between the axles and place the print on top of the upper axle like shown in graphic II.
Start mounting by some push of the board to move between the axles and push “start”- key.
Move away liner manually during mounting process.
Alternative technique:
Place the print on the board
Move this both into the open axles in the middle of the board and close axles to fix position of board and print.
Print should be some larger then board to adjust easy.
Summary of Contents for EASYLAM 140 C
Page 1: ...Operating instructions Laminator Version 1 0 140 C...
Page 15: ...15...
