11
Install - Step 1 continued
Install the storage-system hardware
Install the storage-system hardware in a rack or cabinet
If your storage-system hardware is already installed in a rack or cabinet, skip this
section and go to "Connect the storage-system back-end ports" (page 22).
This section describes how to install CX4-120 storage-system hardware. In general,
you should install hardware starting at the lowest available rack/cabinet space and
work up from there. We recommend placing the SPE directly above the SPS, and the
DAEs directly above the SPE.
For detailed instructions on installing your storage-system hardware, refer to the
EMC Rails and Enclosures CX4 Series Storage Systems Field Installation Guide
(300-007-436) located on the Powerlink website.
WARNING
!
The equipment is heavy and should be installed into a rack by two
people. To avoid personal injury and/or damage to the equipment, do
not attempt to lift and install the unit into a rack without a
mechanical lift and/or help from another person
.
1. Install the standby power supply (SPS) first.
The SPS is a
required system component
of all AC systems that allows write caching and
prevents data loss in case of a power failure.
