31
Install - Step 6 continued
Initialize and enroll the storage system
If your server is behind a firewall, open the TCP/IP port 2162 (outgoing) and port 2163
(incoming). The initialization utility will not function properly if these ports are not opened.
2. Run the Storage System Initialization Utility on the host.
a. If the utility did not launch automatically after installation, select
Start > Programs > EMC > Unisphere Initialization
from the toolbar.
b. The utility automatically scans the subnet for storage systems. Uninitialized
systems are identified by hardware serial number. (You recorded your
hardware serial number on the worksheet in "Preinstall - Step 2 Plan network
connections" on page 3.)
If the discovery operation did not find the storage system that you are installing, verify that the
storage system’s management ports are properly cabled to the LAN on which the host resides. The
storage system and host must both reside on the same subnet.
c. From the
Uninitialized Systems
list, select the serial number of the storage
system to initialize and click
Next
.
d. Use your completed worksheets to provide all the information the utility
requests.
When finished, the utility boots the storage system.
3. Go to http:Powerlink.emc.com to gain access to software downloads. Choose
Home
>
Support
>
Product and Diagnostic Tools
>
CLARiiON Tools
>
Register
and enter your storage system serial number.
