8
Step 5
Install the Storage System in the Cabinet
If your CX700 SPE enclosure or DAEs are not already installed in a cabinet, install
them using the instructions for installing a 4U device (SPE) or 3U device (DAE2 or
DAE2P) in the
EMC Rails and Enclosures Field Installation Guide
.
IMPORTANT
The disk modules in slots 0 through 4 of the first DAE (enclosure 0,
loop 0) provide mirrored boot and recovery capability, and are preconfigured
according to their slot assignment before shipment. Do not move a module in
slots 0 through 4 from its assigned slot to another slot. Remove it only to replace a
failed disk.
Do not configure an ATA model DAE as EA 0, loop 0. ATA enclosures do not
support the boot and SPS requirements of the first disk-array enclosure in a
storage system.