AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a NetWare Server
7
Installing HBAs in the Server
2. Remove the outer covers from the server so that you can access
the PCI bus slots.
For information on how to remove the covers from the server,
refer to the installation documentation supplied with the server.
3. Put on an ESD wristband, and clip its lead to bare metal on the
server’s chassis.
4. For the HBA
you are adding, do the following:
a. If the server has a removable PCI card cage, remove it.
b. Locate an empty PCI bus slot.
c. Remove the filler panel from the slot and save it.
d. If your server has a low profile, replace the mounting bracket
on the HBA bracket with the low-profile mounting bracket
provided with your HBA.
e. Carefully align the HBA with the slot, and then firmly and
evenly press the HBA into the slot.
f. Secure the HBA
to the slot with the screw or clip from the filler
panel.
g. If you have another HBA to install, repeat steps b through f.
h. If you removed a PCI card cage, replace it.
5. Replace the covers you removed from the server.
6. Remove the ESD wristband.
7. Plug the server power cord into the power outlet.
8. Power up the server.
You have completed the installation of the HBA.
