Figure 7 Removing a disk filler module
1
2
CL5283
Unpacking a part
Procedure
1. Wear ESD gloves or attach an ESD wristband to your wrist and the enclosure in which
you are installing the part.
2. Unpack the part and place it on a static-free surface.
3. If the part is a replacement for a faulted part, save the packing material to return the
faulted part.
Installing a new or replacement disk
Before you begin
Use ESD gloves or attach an ESD wristband to your wrist and the enclosure in which you
are installing the disk.
Refer to
while performing the procedure that follows.
NOTICE
If you are installing multiple disks in a storage system that is powered up, wait at least 10
seconds before sliding the next disk module into position.
Procedure
1. Align the disk with the guides in the slot.
2. With the disk latch fully open, gently push the disk into the slot.
The disk latch begins to rotate downward when its tabs meet the enclosure.
3. The disk latch begins to rotate downward when its tabs meet the enclosure.
Disk Replacement for a DAE Shelf
Unpacking a part
31
Summary of Contents for CloudBoost 100
